[May-2024 Newly Released] 300-815 Dumps for CCNP Collaboration Certified
Updated Verified 300-815 dumps Q&As - 100% Pass
NEW QUESTION # 41
Refer to the exhibit.
Users report that when they dial to Cisco Unity Connection from an external network, they cannot enter any digits. Assuming only in-band DTMF is supported, what is a reason for this malfunction?
- A. The rtpmap:0 value for the negotiated codec is marking DTMF as inactive.
- B. The negotiated RTP port is outside of the range described by RFC, so inband DTMFs do not work.
- C. There is SIP Delayed Offer. DTMF is supported only in Early Offer.
- D. No DTMF is negotiated.
Answer: D
NEW QUESTION # 42
An engineer must configure a secure SIP trunk with a remote provider, with a specific requirement to use port
5065 for inbound and otubound traffic. Which two items must be configured to complete this configuration? (Choose two.)
- A. Incoming Port in SIP Trunk Security Profile configuration
- B. Incoming Port in SIP Information section of the SIP Trunk configuration.
- C. Destination Port in SIP Trunk Security Profile configuration
- D. Destination Port in SIP Information section of the SIP Trunk configuration
- E. Incoming Port in Security Information of the SIP Profile configuration.
Answer: A,D
NEW QUESTION # 43
Refer to the exhibit.
A call mode through the Cisco Unified Border Element to pilot 2000 is foiling. What is causing the call to foil?
- A. VAD was not disabled on the outgoing dial poor.
- B. The Cisco Unified Border Element is not receiving a response to its OPTION keepahves.
- C. No codecs are configured on the dial peers
- D. The destination pattern is incorrect for the dialed number.
Answer: D
NEW QUESTION # 44
Which two descriptions of the Standard Local Route Group deployment are true? (Choose two.)
- A. can be associated under the route group
- B. can be assigned directly to the route pattern
- C. chooses the route group that is configured under the device pool of the called-party device
- D. can be associated only under the route list
- E. chooses the route group that is configured under the device pool of the calling-party device
Answer: D,E
NEW QUESTION # 45 
Refer to the exhibit. Users report that when they dial to Cisco Unity Connection from an external network, they cannot enter any digits. Assuming only in-band DTMF is supported, what is a reason for this malfunction?
- A. The rtpmap:0 value for the negotiated codec is marking DTMF as inactive.
- B. The negotiated RTP port is outside of the range described by RFC, so inband DTMFs do not work.
- C. There is SIP Delayed Offer. DTMF is supported only in Early Offer.
- D. No DTMF is negotiated.
Answer: D
Explanation:
Section: Signaling and Media Protocols
NEW QUESTION # 46
When configuring hunt groups, where do you add the individual directory numbers that will be part of the group?
- A. hunt pilot
- B. line group
- C. route group
- D. hunt list
Answer: B
Explanation:
Reference:
https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/12_0_1/systemConfig/ cucm_b_system-configuration-guide-1201/cucm_b_system-configuration-guide-1201_chapter_010101.html
NEW QUESTION # 47
Refer to the exhibit.
A company needs to ensure that all calls are normalized to E164 format. Which configuration will ensure that the resulting digit string + 14085554001 is created and will be routed to the E.164 routing schema?
- A. Calling Party Transformation Mask of +1408555XXXX
- B. Calling Party Transformation Mask of +14085554XXX
- C. Called Party Transformation Mask of + 1408555[35)XXX
- D. Called Party Transformation Mask of + 14085554XXX
Answer: D
NEW QUESTION # 48
Refer to the exhibit.
How many maximum hops can an ILS update traverse?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A
NEW QUESTION # 49
Where on Cisco Unified Communications Manager do you configure the standard local route group for a group of devices?
- A. Call Routing > Emergency Location > Emergency Location (ELIN) Groups
- B. Call Routing > Route/Hunt > Local Route Group Names
- C. System > Location Info
- D. System > Device Pool
Answer: B
Explanation:
Reference:
https://www.uccollabing.com/configuring-standard-local-route-group-cucm/
NEW QUESTION # 50
Refer to the exhibit.
DN 1003 was the last to ring during the most recent call. Which hunting method ensures that DN 1005 is presented with the next call when the hunt pilot is dialed?
- A. peer
- B. parallel
- C. call-blast
- D. sequential
Answer: A
NEW QUESTION # 51
Which call pickup feature allows users to pick up incoming calls in a group that is associated with their own group?
- A. Directed Call Pickup
- B. BLF Call Pickup
- C. Group Call Pickup
- D. Other Group Pickup
Answer: D
Explanation:
Reference:
https://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/4_1_3/ccmsys/ a07cpick.html#wp1022865
NEW QUESTION # 52
For s SIP to SIP call flow, when does Cisco Unified Border Element require transcoding resources for DTMF?
- A. interworking between an OOB method and RFC2833 for flow-through calls
- B. interworking between h245-signal and rtp-nte
- C. interworking between an OOB method and RFC2833 for flow-around calls
- D. interworking between h245-alpha numeric and sip-kpml
Answer: C
NEW QUESTION # 53
The Cisco Unified Communications Manager Dialed Number Analyzer allows analysis of calls from which two devices? (Choose two.)
- A. IP phones
- B. translation patterns
- C. device pools
- D. CTI ports
- E. CTI route points
Answer: A,D
Explanation:
Reference:
https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/dna/11_5_1/ CUCM_BK_CBA47A6E_00_cucm-dna-guide-115/CUCM_BK_CBA47A6E_00_cucm-dna-guide- 115_chapter_01.html#CUCM_TP_A5DA99E0_00
NEW QUESTION # 54
An engineer is troubleshooting Cisco Device Mobility and find that the phone has roamed to a building that is assigned to a different device pool but has not changed its device pool accordingly What action resolves the issue?
- A. Set correct Location under Current Device Mobility Settings
- B. Enable SRST under Current Device Mobility Settings
- C. Set the correct subnet under Device Mobility Info.
- D. Set Device CSS under Current Device Mobility Settings.
Answer: C
NEW QUESTION # 55
Refer to the exhibit.
Which change to the translation rule is needed to strip only the leading 9 from the digit string 9123548?
- A. rule 1 /^9\(.*\)/A1/
- B. rulel /^9\(\d*\)/^1/
- C. rule 1/^9123548/^1/
- D. rulel /.*\(3548S\)/^1/
Answer: A
NEW QUESTION # 56
An engineer must configure call queuing under a Hunt Pilot. After the engineer receives the audio file that will be played to callers during queuing, which two steps should be taken to complete the configuration? (Choose two.)
- A. Upload the audio file in "MOH Audio File Management" via CM Administration GUI
- B. Assign the uploaded audio file to "Network Hold MOH Source & Announcements" under Hunt Pilot's Queuing section.
- C. Assign the uploaded audio file to the hunting Line Group member's "User Hold MOH Audio Source
- D. Upload the audio file in "TFTP File Management" via OS Administration GUI
- E. Assign the uploaded audio file to the hunting Line Group member's "Network Hold MOH Audio Source".
Answer: B,D
NEW QUESTION # 57
Which configuration must an administrator perform to display Translation Pattern operations in Cisco Unified Communications Manager SDL traces?
- A. Set up the Digit Analysis Complexity in Service Parameters for Cisco Unified CM to TranslationAndAlternatePatternAnalysis.
- B. Check the Translation Patterns Analysis check box in Micro Traces on the Cisco Unified CM Serviceability page.
- C. Enable the Detailed Call Analysis option under Enterprise Parameters for Unified CM.
- D. By default, the Translation Patterns operations are printed in SDL traces, so no additional configuration is necessary.
Answer: D
NEW QUESTION # 58
Refer to the exhibit.
In an active SIP call between phone user A and phone user B, phone A initiates a call transfer to phone user C.
Which two scenarios are correct? (Choose two.)
- A. As soon as Phone_A presses the Transfer button for the first time, Phone_B hears the MOH and the MOH audio is chosen from Phone_B User Hold MOH Audio Source settings.
- B. As soon as Phone_A presses the Transfer button for the first time, Phone_B hears the MOH and the MOH audio is chosen from Phone_A User Hold MOH Audio Source settings.
- C. Phone_B sends a SIP-REFER message to the Cisco Unified CM with Phone_C information in the Refer-To section.
- D. Phone_A sends a SIP-REFER message to the Cisco Unified Communications Manager with Phone_C information in the Refer-To section.
- E. As soon as Phone_A presses the Transfer button for the first time, Phone_B hears the music on hold and the MOH audio is chosen from Phone_A Network Hold MOH Audio Source settings.
Answer: A,D
NEW QUESTION # 59
Refer to the exhibit.
In an active SIP call between phone user A and phone user B, phone A initiates a call transfer to phone user C.
Which two scenarios are correct? (Choose two.)
- A. As soon as Phone_A presses the Transfer button for the first time, Phone_B hears the MOH and the MOH audio is chosen from Phone_A User Hold MOH Audio Source settings.
- B. As soon as Phone_A presses the Transfer button for the first time, Phone_B hears the MOH and the MOH audio is chosen from Phone_B User Hold MOH Audio Source settings.
- C. Phone_B sends a SIP-REFER message to the Cisco Unified CM with Phone_C information in the Refer-To section.
- D. Phone_A sends a SIP-REFER message to the Cisco Unified Communications Manager with Phone_C information in the Refer-To section.
- E. As soon as Phone_A presses the Transfer button for the first time, Phone_B hears the music on hold and the MOH audio is chosen from Phone_A Network Hold MOH Audio Source settings.
Answer: D,E
NEW QUESTION # 60
......
Latest 300-815 Exam Dumps Cisco Exam from Training: https://www.prepawayete.com/Cisco/300-815-practice-exam-dumps.html
New 2024 Latest Questions 300-815 Dumps - Use Updated Cisco Exam: https://drive.google.com/open?id=1rPsM8ujzmBjmCQThVjMGOTJD6UXqh_dt